Bosch GGS Professional 28 CE Notice Originale page 7

Product Description and
Specifications
Read all the safety and general instructions.
Failure to observe the safety and general in-
structions may result in electric shock, fire
and/or serious injury.
Please observe the illustrations at the beginning of this oper-
ating manual.
Intended Use
The power tool is intended for grinding and deburring metal
with corundum grinding tools, as well as for working with
sanding belt tools.
Technical Data
Straight grinder
Article number
Rated power input
Power output
Rated speed
Speed adjustment range
Max. collet diameter
Spanner flat on the
– Clamping nut
– Grinding spindle
Spindle collar diameter
Grinding tool diameter, max.
Constant electronic control
Speed preselection
Weight according to EPTA-Proced-
ure 01:2014
Protection class
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
Fitting
Pull the plug out of the socket before carrying out any
u
work on the power tool.
Fitting the Abrasive Tools (see figure A)
Only use open-ended spanners that are suitable and
u
undamaged (see "Technical Data").
– Clean the grinding spindle (3) and all the parts to be fit-
ted.
– Use an open-ended spanner (8) on the spanner flat of the
grinder spindle (3) to hold it in place.
Loosen the clamping nut (2) by placing an open-ended
Bosch Power Tools
Product Features
The numbering of the product features refers to the diagram
of the power tool on the graphics page.
(1) Collet
(2) Clamping nut
(3) Grinding spindle
(4) Spindle collar (insulated gripping surface)
(5) On/off switch
(6) Speed preselection thumbwheel
(7) Handle (insulated gripping surface)
(8) Open-ended spanner on the grinding spindle
(9) Open-ended spanner on the clamping nut
A) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
GGS 28 CE
3 601 B20 1..
W
W
-1
min
-1
min 10000−30000
mm
mm
mm
mm
mm
kg
spanner (9) on the spanner flat and turning it counter-
clockwise.
– Insert the straight shank of the grinding tool all the way
into the collet (1).
– Hold the grinding spindle (3) with the open-ended span-
ner (8) and tighten the application tool by placing the
open-ended spanner (9) on the spanner flat and turning it
clockwise.
The grinding tools must run completely concentrically. Do
not continue to use damaged grinding tools that are out of
balance. If the grinding tools are out of balance, they should
be replaced.
English | 7
GGS 28 LCE
3 601 B21 1..
650
380
30000
10000−30000
8
19
19
43
50
●
●
1.4
/ II
1 609 92A 5T0 | (05.06.2020)
A)
A)
650
380
30000
8
19
13
43
50
●
●
1.6
/ II