Publicité
Les langues disponibles
Les langues disponibles
WARNING
• Always use an assistant or mechanical lifting
equipment to safely lift and position the fl at panel
display.
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
• Be careful not to pinch fi ngers when pushing display
from the bottom.
Mounting Display: Slowly hook adapter brackets
4
(B) onto top rail of front plate wall arm (A) then
swing display down as shown in fi gure 4.1. Adapter
bracket hooks must fully engage adapter plate as
shown in detail 1. Using allen wrench (M), turn
safety/security screws on adapter brackets (B)
clockwise till screw tip securely contacts adapter
plate as shown in cross section.
Removing Display: To remove display from mount,
loosen safety/security screws, swing display away
from mount, and lift display off of mount.
For VESA 200 x 200 Mounting Pattern
Remove eight M6 x 8mm screws and unhook top and bottom rails from front plate.
5
TOP RAIL
M6 X 8MM
SCREWS
BOTTOM RAIL
fi g. 4.1
FRONT PLATE
9 of 41
ISSUED: 01-25-12 SHEET #: 095-9370-6 09-20-13
B
TOP RAIL
DETAIL 1
BOTTOM RAIL
B
CROSS SECTION
A
A
A
SAFETY/
SECURITY
SCREW
Publicité
