LG CBGS3628 Serie Manuel D'installation page 6

en-us_main.book.book Page 6 Friday, November 4, 2022 8:08 AM
6 INSTALLATION
INSTALLATION
Before Installing
Before You Begin
Read these instructions completely and carefully.
Improper installation, adjustment, alteration,
service or maintenance can cause injury or
property damage. For assistance or additional
information, consult a qualified installer, service
agency, manufacturer (dealer) or your gas
supplier.
Installation of this cooktop must conform with
local codes, or in the absence of local codes, with
the National Fuel Gas Code, ANSI Z223.1/NFPA 54
or, in Canada, the Natural Gas and Propane
Installation Code, CSA B149.1.
As with any appliance using gas and generating
heat, there are certain safety precautions you
should follow. You will find these precautions in
the IMPORTANT SAFETY INSTRUCTIONS chapter.
Read them carefully.
IMPORTANT:
• Save these instructions for the local electrical
inspector's use.
• Observe all governing codes and ordinances.
NOTE
• Installer: Leave these instructions with the
appliance after installation is completed.
• Consumer: Keep the owner's manual and
installation manual for future reference.
• This appliance must be properly grounded.
• The electrical diagram is in an envelope attached
to the back of the cooktop.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is
not covered under the Warranty.
• Remove all tape and packaging.
• Make sure the burners are properly seated and
level.
• Take the accessory pack off of the cooktop.
• Check to be sure that no cooktop parts have
come loose during shipping.
In the Commonwealth of
Massachusetts
• This product must be installed by a licensed
plumber or gas fitter.
• When using ball type gas shut-off valves, they
must be the T-handle type.
• A flexible gas connector, when used, must not
exceed 3 feet in length.
Tools and Materials
Tools You Will Need
a
Phillips Screwdriver
b
Flat-blade Screwdriver
c
Open-end or Adjustable Wrench
d
Pencil and Ruler
e
Pipe Wrench (2 ea) (one for support)
Materials You May Need
a
Joint Sealant
b
Pipe Fittings
c
Shut Off Valve
d
Flexible Connector
• Gas line shut-off valve