Pre-Installation Information - Philips X-tremeVision LED Mode D'emploi

Pre-installation Information

4
• Check to make sure that the inside diameter
of the air-tight cover for your lamp is at least
60 mm. If it is too small, there is the risk of
unsuccessful installation of the heat sink and
the control box.
Min60mm
26mm
Figure-1
• The LED-HL [≈H7] lamp is not for use with
all types of cars. Please consult a professional
sales representative.
• Please have a technician at a professional ser-
vice location install the LED-HL [≈H7] lamp.
• If it is found, after the LED-HL [≈H7] lamp is
installed, that there is no cut-off line for the
low-beam light pattern, please switch back to
your previous halogen H7 lamp.
• Applicable car types: Please refer to the over-
view of applicable cars.
5 Installation steps for projector lamps
• Swing to open the air-tight cover for the
original headlight.
Figure-2
• Loosen the spring latch and remove the halogen
lamp from the existing headlight assembly.
• Secure the control box with two ties, as
shown below.
50mm
• Secure the control box with the third and the
fourth ties, as shown below.
• Secure the ties to the neck of the lamp reflector.
• Fasten the ties and finally secure the control box
as follows.
5