Other Information - Philips X-tremeVision LED Mode D'emploi

• The LED-HL [≈H7] lamp has a relatively high
temperature; do not let it get close to flammable
materials or parts.
• For the best heat-sink effects, do not wrap the
control box completely with tape or sponge.
m Warnings
• When working, the LED-HL [≈H7] lamp and the
LED drive box will be at a very high tempera-
ture. Do not touch them directly with fingers or
skin, to avoid scalding.
4
• The LED illumination of the LED-HL [≈H7]
lamp is of high intensity; do not look directly at
the LED-HL [≈H7] lamp, to avoid eye damage.
• Before you remove the halogen H7 lamp,
make sure that the lamp's temperature has
dropped to room temperature, to avoid
burning fingers or skin.
• Do not let the LED-HL [≈H7] lamp become
exposed to dust, grease or stains, or scratch
the surface of the LED; this will damage the
LED-HL [≈H7] lamp.
• Do not let children touch the LED-HL
[≈H7] product.
m Other Information
• Please make sure that you purchase the
Philips LED-HL [≈H7] lamp through the
correct channels.
• After the lamp is installed, please check if the light
pattern is okay, and make sure that the indicators
on the dash board are working normally and that
nothing is abnormal.
• After the lamp is installed, please check whether
the air-tight cover is properly sealed to avoid
undesirable sealing; and whether the control box
and the wiring harness are firmly in place, and not
interfering with other parts inside the lamp or the
fan above the lamp.