Makita XBU02 Manuel D'instructions page 37

2. Push the front hand guard forwards with the
back of your hand. Make sure that the chain saw
comes to an immediate standstill.
3
1
2
1. Front hand guard 2. Unlocked position
3. Locked position
Checking the run-down brake
CAUTION: If the saw chain does not stop
within two seconds in this test, stop using
the chain saw and consult our authorized
service center.
Run the chain saw then release the switch trig-
standstill within two seconds.
2
3
13
Adjusting the chain lubrication
You can adjust the oil pump feed rate with the
amount of oil can be adjusted in 3 steps. Open
the cap to adjust the adjusting screw.
1. Cap 2. Adjusting screw
Carabiner (rope attachment point)
You can hang the tool by attaching the rope to
the carabiner. Pull up the carabiner, and then tie
it with the rope.
1. Carabiner
Electronic function
for easy operation.
shock, and makes the tool start smoothly.
ENGLISH
1
2
1