Makita XBU02 Manuel D'instructions page 35

Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use
and the ambient temperature, the indication
may differ slightly from the actual capacity.
Tool / battery protection system
automatically stop during operation if the tool or bat-
tery is placed under one of the following conditions:
Overload protection
When the battery is operated in a manner that
causes it to draw an abnormally high current, the
tool automatically stops and the main power lamp
blinks in green. In this situation, turn the tool off and
stop the application that caused the tool to become
Overheat protection
When the tool or battery is overheated, the tool
stops automatically and the main power lamp
lights up in red. In this case, let the tool and bat-
tery cool before turning the tool on again.
NOTE: In high temperature environment, the
overheat protection likely to work and the tool
stops automatically.
Overdischarge protection
When the battery capacity is not enough, the tool
stops automatically and the main power lamp
blinks in red. In this case, remove the battery
from the tool and charge the battery.
Remaining
capacity
Blinking
75% to
100%
50% to
75%
25% to
50%
0% to
25%
Charge
the
battery.
-
tery may
have
malfunc-
tioned.
Main power switch
WARNING: Always turn off the main
power switch when not in use.
turn off, press the main power switch again.
1. Main power lamp 2. Mode indicator
3. Main power switch
NOTE:
the switch trigger is pulled under unoperatable
lowing conditions.
while holding down the lock-off lever and
the switch trigger.
chain brake is applied.
holding down the lock-off lever and pulling
the switch trigger.
NOTE:
main power switch will automatically shut
down when the switch trigger is not pulled for
a certain period after the main power switch is
turned on.
tool is turned off, press the main power switch for
a few seconds until the mode indicator lights up
in green.
11
ENGLISH
1
-
2
3