Barazza 1PIDC30N Manuel D'installation Et D'utilisation page 23

• Chef Cook Function:
Chef Cook function is a features which enables
3 cooking zones with different heating powers.
Starting from the left to the right.
To activate this function, touch the Chef Cook
function (E key).
To disable it, touch the Chef Cook function key.
The following power levels are set and dissipated
as soon as a suitable cookware is placed onto the
cooking zones:
Number zone
2
1
4
• Warming level:
This function is used to keep boiled food warm.
The power level is between 0 and 1. To activate
the warming level you have to select the zone (L
zone), and press the D key. The display will show
.
• Power management:
The hob support power management to prevent
the mains connection from overloading. The pow-
er management is prioritazing: the cooking zone
which heating power has been increasing at last
will get the desired heating power, and the other
cooking zone will be reduced. The reduction of
power will be signaled to the operator by flashing
OFF of the cooking level (L zone) and the its pow-
er will be reduced.
Power level
2
6
9
23
• Power settings:
The power of the all hob can be set from its max-
imum (7.4 kW / 6.7 kW / 3.7 kW) to a minimum
of 1.4 kW, using a step of 100w (0.1 kW), until a
minimum of 1.4W by the user menu.
The user menu is intended for the customer, to
adapt it to his personal needs.
To enter in the user menu, the control must be in
stand-by mode, touch ON / OFF (A key) to turn on
the Touch Control. Then press the ON / OFF con-
trol (A key) again within 3 sec. At this point, the led
of the "special" function (B) of the key will appear.
Command (B) will be active for 60 sec. maximum,
after which you will automatically exit the menu.
By pressing, within these 60 seconds, and hold-
ing down B key, the LEDs of the cooking zones (L
area) appear; at this point the user must press the
cooking zones (L area) clockwise; now in the L
area will appear " " and a number (which identify
U
the menus kind), to manage the power you have
to choose " ". Now the user can press where is
0
show the power, and with the slider (H area) it's
possible to manage the power.
To confirm it, simply press the OFF key (A).
In the following table there are described the im-
plemented user menu items:
EN