Beta 3026/SP Mode D'emploi page 7

INSTRUCTIONS FOR USE
Always use the following personal protective equipment:
• Safety shoes
• Safety gloves
Make sure you are in a safe position, keeping a proper balance at all times. A safe working position and a
proper body posture enable better control of unexpected situations.
UNIVERSAL GEARBOX SUPPORT USE AND CARE
• Do not overload the universal gearbox support, and always check that it is free from defects.
• While handling the load, always make sure that it does not move.
• Distribute the load in such a way that it is placed as centrally as possible to the jack below.
• Do not use the support with any overhanging loads, beyond the wheels of the jack below.
• Make sure that the load has been fastened with the ratchet belt, to avoid sudden falls.
• Store the universal support out of the reach of children. Do not allow persons unfamiliar with these instructions to
operate the universal support.
• Do not modify the universal support. This can reduce the effectiveness of safety measures and increase
operator risk.
‡ +DYH WKH XQLYHUVDO VXSSRUW UHSDLUHG RQO\ WKURXJK D TXDOL¿HG UHSDLU SHUVRQ 2QO\ XVH RULJLQDO UHSODFHPHQW SDUWV
UNIVERSAL GEARBOX SUPPORT SAFETY
• Operators and maintenance personnel should be physically able to handle the universal gearbox support
and its load.
• Make sure the respective supporting arms are correctly adjusted according to the load.
• Periodically check that the universal gearbox support is free from defects.
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING UNIVERSAL GEARBOX SUPPORT
)DLOXUH WR REVHUYH WKH IROORZLQJ ZDUQLQJV PD\ UHVXOW LQ SK\VLFDO LQMXU\ DQGRU GLVHDVH
ALWAYS WEAR SAFETY SHOES
ALWAYS WEAR HEAT PROTECTION GLOVES
TECHNICAL DATA
LENGTH
WIDTH
HEIGHT
RUBBER SUPPORT
WEIGHT
JACK STAND ADAPTOR
TIGHTENER RATCHET BELT
MAXIMUM CAPACITY
450 mm
310 mm
300 mm
130 x 70 x 50 mm
7.5 Kg
Ø 25 – 30 mm
25 X 130 mm
150 Kg
EN
7