CASO DESIGN TO 32 Mode D'emploi page 45

Attention
► If dampness penetrates into the device, this can damage the electronic components.
Please ensure that no liquid can enter the interior of the device through the ventilation
slots.
► Do not use any aggressive or abrasive cleaning agents or solvents.
► Do not scrape off stubborn dirt with hard items.
16.2 Cleaning
Danger of fire
► Always remove grease residues in the device, as these residues can otherwise ignite.
Clean the housing and the crumb tray with a damp cloth.
Clean the door with a soft cloth and some glass cleaner or a mild detergent.
Thoroughly wipe the bottom, the walls and top of the interior after each use with a damp soft
cloth or a soft cleaning sponge.
Thoroughly dry the accessory and the device before using them again.
Slide the crumb tray back into the device after cleaning.
17 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
17.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out any
repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and damages
to the device.
17.2 Causes and rectification of faults
The following table assists in localizing and rectifying minor faults.
Problem
The device is not functioning
Please note
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
Solution
• Please check whether the power plug is properly
plugged.
45