Publicité
Les langues disponibles
Les langues disponibles
Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position of the ignition
is switched.
The leads are not matched correctly with the car's
accessory power connector.
During playback or reception, demonstration
mode starts.
If no operation is performed for 5 minutes with
"DEMO-ON" set, demonstration mode starts.
t Set "DEMO-OFF" (page 9).
The display disappears from/does not appear
in the display window.
• The dimmer is set "DIM-ON" (page 9).
• The display disappears if you press and hold (OFF).
t Press and hold (OFF) on the unit until the
display appears.
• The connectors are dirty (page 14).
The Auto Off function does not operate.
The unit is turned on. The Auto Off function activates
after turning off the unit.
t Turn off the unit.
Card remote commander operation is not
1
possible.*
Make sure the insulation film has been removed
(page 5).
CD/MD playback
The disc cannot be loaded.
• Another disc is already loaded.
• The disc has been forcibly inserted upside down or in
the wrong way.
The disc does not playback.
• Defective or dirty disc.
• The CD-Rs/CD-RWs are not for audio use (page 12).
MP3/WMA files cannot be played back.*
The disc is incompatible with the MP3/WMA format
and version (page 13).
MP3/WMA files take longer to play back than
2
others.*
The following discs take a longer time to start
playback.
– a disc recorded with a complicated tree structure.
– a disc recorded in Multi Session.
– a disc to which data can be added.
The display items do not scroll.
• For discs with very many characters, those may not
scroll.
• "A.SCRL" is set to "OFF".
t Set "A.SCRL-ON" (page 10).
t Press and hold (DSPL) (SCRL).*
The sound skips.
• Installation is not correct.
t Install the unit at an angle of less than 45° in a
sturdy part of the car.
• Defective or dirty disc.
16
The operation buttons do not function.*
The disc will not eject.
Press the RESET button (page 5).*
Press Z (eject) (page 6).*
Radio reception
The stations cannot be received.
The sound is hampered by noises.
• Connect a power antenna (aerial) control lead (blue)
or accessory power supply lead (red) to the power
supply lead of a car's antenna (aerial) booster (only
when your car has built-in FM/AM antenna (aerial)
in the rear/side glass).
• Check the connection of the car antenna (aerial).
• The auto antenna (aerial) will not go up.
t Check the connection of the power antenna
• Check the frequency.
Preset tuning is not possible.
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
Automatic tuning is not possible.
• Setting of the local seek mode is not correct.
t Tuning stops too frequently:
t Tuning does not stop at a station:
• The broadcast signal is too weak.
t Perform manual tuning.
During FM reception, the "ST" indication
flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
t Set "MONO-ON" (page 10).
An FM program broadcast in stereo is heard in
monaural.
2
The unit is in monaural reception mode.
t Set "MONO-OFF" (page 10).
*1 CDX-GT320/GT32W only
*2 CDX-GT320/GT32W/GT220/GT22W only
*3 CDX-GT220/GT22W/GT120/GT12W only
Error displays/Messages
BLANK (CDX-GT320/GT32W only)
Tracks have not been recorded on the MD.
t Play an MD with recorded tracks.
ERROR*
• The disc is dirty or inserted upside down.
2
t Clean or insert the disc correctly.
• A blank disc has been inserted.
• The disc cannot play due to a problem.
t Insert another disc.
3
(aerial) control lead.
Set "LOCAL-ON" (page 10).
Set "MONO-ON" (page 10).
2
1
1
1
*
1
*
Publicité
