Lagrange Glacons Express' 489 Notice page 67

START-UP AND USE
ST USE
1
When you unpack the unit, make sure that you remove all of the
*
packaging materials.
Make sure that all of the parts and accessories are present and intact.
*
Before using your unit, thoroughly clean all of the parts (see
*
upkeep section).
When you turn the unit on, the On/Off indicator light blinks.
This means that the unit is awaiting instructions.
USE OF THE CONTROL PANEL
The on/off button indicator light will blink once the
unit has been plugged in. The unit is then in
standby mode.
To start the unit, press the on/off button again,
the indicator light will turn on.
You can then select the desired ice cube size.
You can stop the making of ice cubes at any time
by pressing the same button again to put the unit
in standby. The indicator light will start blinking.
All manuals and user guides at all-guides.com
67
By default, the ice cube size will be large.
Select the desired ice cube size by pressing
successively. An indicator light will go on above
the corresponding illustration.
Pressing the selection button for
the automatic cleaning function. The automatic
cleaning function is composed of
cycles. The ice cube size indicator lights will blink
during the process and then the unit will go into
standby mode. You must then drain the water
through the drain plug.
When the ice cube dish is full, the indicator light
blinks and the machine stops working.
Empty the ice cube dish and put it back in place.
The indicator light goes off when there is sufficient
room in the dish.
The unit will automatically make new ice cubes.
ENG
3 seconds will start
5 system cleaning