Hitachi DS 12DVB2 Instructions De Sécurité Et Mode D'emploi page 22

English
THE SCOPE AND SUGGESTIONS FOR USES
Work
Wood
Drilling Steel
Aluminum
Small
screw
Screw
tightening
Wood
screw
HOW TO SELECT TIGHTENING TORQUE
Cap
position
1 Approximately 9 in-lbs. (10 kg-cm)
3 Approximately 15 in-lbs. (17 kg-cm)
7 Approximately 23 in-lbs. (26 kg-cm)
13 Approximately 35 in-lbs. (40 kg-cm)
17 Approximately 43 in-lbs. (49 kg-cm)
22 Approximately 52 in-lbs. (60 kg-cm)
High speed: Approximately 78 in-lbs.
Low speed: Approximately 320 in-lbs.
NOTE:
The selected content shown in Table 5 indicates the differences according to screw
type, screw size and material used.
CAUTION:
G
While operating the Cordless driver drill, take care not to lock the motor.
If the motor is locked, immediately turn the power off.
If the motor is locked for a while, the motor or battery will be burnt.
G
Do not tighten too strongly as the screw heads will be damaged.
22
Table 4
Cap position
1 – 22
1 –
Table 5
Tightening torque
(90 kg-cm)(DS12DVB2)
Approximately 78 in-lbs.
(90 kg-cm)(DS14DVB2)
Approximately 96 in-lbs.
(110 kg-cm)(DS18DVB2)
(367 kg-cm)(DS12DVB2)
Approximately 346 in-lbs.
(400 kg-cm)(DS14DVB2)
Approximately 400 in-lbs.
(460 kg-cm)(DS18DVB2)
Suggestions
Use for drilling purpose.
Use the bit and socket matching the screw
diameter.
Use after drilling a pilot hole.
Operation example
Machine screw
tightening.
Screw tightening for
soft wood material.
Screw tightening for
hard wood material.
Thick screw tightening.
When used as a drill.