Trust ZCTS-808 Mode D'emploi page 3

COMPATIBILITY
The contact sensor works with the Z1 ZigBee Bridge and the ICS-2000.
1. (RE)PLACE THE BATTERY
A A
Remove the backplate from the contact sensor.
B B
Open de battery cover using a flat screwdriver.
C C
Place the included CR2032 battery in the contact sensor. Note the positive
and negative polarity in the compartment. Close the battery cover.
2. INDICATORS
The contact sensor contains a LED indicator (This is not a button) to show the
status of the contact sensor. Please see below the meaning of the different
LED indications.
LED FUNCTION TABLE
Connection mode
Connected successfully
Sensor reset
Sensor triggered (When the sensor is
opened for more then 10 mm)
All manuals and user guides at all-guides.com
LED will flash once per second
for approximately 1 min.
LED will stop flashing
LED will flash fast
LED will flash once
A
A
B