OHAUS Scout SKX Serie Guide De Démarrage Rapide page 4


Scout SKX Balances
3. If needed, press & hold Mode key until [SPEC.Gr] is
displayed, then release.
4. [Air.wWt] (Air weight) is displayed, place weight on the
hook
5. Press Yes to store the dry weight value.
6. [wW.wWt] (Wet weight) is displayed, place weight in the
water.
7. Press Yes to get the final specifiec gravity value.
Note: "G" indicates a specific gravity value; and has no
unit of measure.
For large samples it is recommended to use the weigh
below feature (weigh below hook located in battery
compartment).
Mole Weighing Mode [mMoLE]
1. If needed, press and hold the Mode key until [mMoLE] is displayed, then release.
2. [Clr.mMS] is displayed.
2. Press the Yes key to clear the stored Molar Mass. Press the No key to recall the
existing Molar Mass. If no Molar Mass was stored, the [Clr.mMS] display is skipped
and inputting a Molar Mass is required.
3. If there is a Molar Mass stored, the current Molar Mass will be displayed and
flashing.
4. Press the No key to begin editing the Molar Mass.
5. Press the No/Back key to increment/decrement the flashing digit.
7. Press the Yes key to accept the value and move one digit to the right.
Notes: If the setting exceeds the limit, the display returns to the previously stored
value. The available settings are from 0.01 to 999.99. The Molar Mass unit is g/mol.
ADDITIONAL FEATURES
 Connecting the Interface
Use an optional interface connectivity kit to
connect the balance either to a computer,
printer or OHAUS auxiliary display.
Below Interface kit accessories are available:
RS232, USB Host, USB Device, Ethernet,
*
Bluetooth .
* Interface kits may vary according to local regulations

Scout SKX Balances
All manuals and user guides at all-guides.com
iv
Quick Start Guide
Interface connection on the rear of
the balance:
Interface
connection AC Adapter
Jack
Ohaus Corporation www.ohaus.com
Air Weight
Wet Weight
Security Slot