Indesit CAA 55 NX Mode D'emploi page 13

DOOR REVERSAL
Warning: Before attempting to remove the doors, switch off the electrical supply and pull out the mains plug.
It is recommended that you remove any loose items/fittings from inside the appliance and place food into insulated containers whilst
carrying out this operation.
You may require assistance to carefully lay the appliance onto its back onto suitable protective materials (i.e. original packaging).
Remove the doors
1. Lay down the appliance on its back.
2. Unscrew, remove and retain the bottom hinge.
3. Slightly open the bottom door and slide downward remove and carefully place to one side
4. Remove centre hinge and spacer if fitted.
Slightly open the top door
and slide downwards,
remove and carefully
place to one side.
5. The pin will be removed
and fixed to the
opposite side
6. Use a thin blunt
instrument to remove
the top and bottom
hinge bushes and
blanking plugs from the
doors, take care not to
mark the door handle.
Reposition the blanking
plugs and bushes on
the opposite side.
7. Fit the blanking plugs
provided into the right
hand two centre hinge
holes.
Replacing the doors
1. Slide the top door upwards and locate the top hinge pin into the door bush. Reposition the centre hinge on the opposite side.
2. Carefully slide bottom door upward into the centre hinge pin.
3. Unscrew the bottom hinge pin and
refit it on the opposite side..
4. Fit the bottom hinge making sure that
the door is aligned to the cabinet.
5. Carefully stand the appliance upright
in it's required location and make
sure it is sitting level on the floor.
Open and close the doors checking
that the gasket makes a good seal
without any gaps when the doors are
closed.
Note: Replace loose items/fittings back
into the appliance and leave for at least
15 minutes before switching back on.
1
GB
2
3
13