Publicité
Les langues disponibles
Les langues disponibles
OPERATING THE SWASH
Special Mode Operations
Eco Mode
In this mode, the water in the tank and the seat temperature can be reduced to one
of two different energy-saving settings.
Standard Eco Mode: Touch Eco Mode until the red indicator light is on for Low
energy-saving, and the seat and water temperature will be heated to 89.6 °F. Once a
person sits on the bidet, the Swash will revert to the last seat and water temperature
settings used. Touch the Eco Mode button until there are no indicator lights on to
deactivate Eco Mode.
High-Efficiency Eco Mode: Touch Eco Mode until the blue indictor light is on for High
energy-saving, and the seat and water temperature will turn off when the bidet is
not in use. Once a person sits on the bidet, the Swash will revert to the last seat and
water temperature settings used. Touch Eco Mode until there are no indicator lights
on to deactivate Eco Mode.
Sitz Bath Mode
In Sitz Bath Mode, water pressure is switched to the lowest level regardless of the
preset water pressure settings. To initiate Sitz Bath Mode, while in a front or rear
wash cycle, touch Nozzle Cleaning. Sitz Bath Mode will automatically run for five
minutes. The Nozzle Cleaning LED will light up indicating Sitz Bath Mode is on.
To stop the Sitz Bath Mode before the end of the five-minute cycle, touch Nozzle
Cleaning.
Seat Sensor Override
1. To activate the Seat Sensor Override, touch and hold Pulse for four seconds. A
beep will sound and the Nozzle Position and Water Pressure/Dry Temp lights
will turn on to indicate that the seat sensor has been turned off. If the Swash is
in Silent Mode, there will not be a beep and only the Nozzle Position and Water
Pressure/Dry Temp lights will turn on.
2. To deactivate the Seat Sensor Override, touch and hold Pulse for four seconds.
Two beeps will sound and the Nozzle Position and Water Pressure/Dry Temp
lights will turn off.
NOTES
• Activation or deactivation of Seat Sensor Override is not possible when seated.
• The Swash cannot be put into Silent Mode while Seat Sensor Override is activated.
• Nozzle Cleaning function will not work when Seat Sensor Override is activated. To
initiate Nozzle Cleaning you must first deactivate Seat Sensor Overide.
18
All manuals and user guides at all-guides.com
Publicité
