Télécharger Imprimer la page

Faber BRS WH A80 Manuel D'utilisation page 5

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
Controls
Button Function
Motor off.
A
Enables / Disables Keyboard Lock mode if pressed and held
for 5 seconds.
Activates speed one.
B
C
Activates speed two.
Activates speed three.
Press and hold the button for approximately 5 seconds,
D
with all the loads turned off (Motor and Lights), to turn the
Activated Charcoal Filter alarm on.
To turn it off, press and hold the button again for 5 seconds.
Activates speed four.
Press and hold for 5 sec. to activate Intensive speed. This speed
E
is timed to run for 6 minutes. At the end of this time the system
will return to the speed set previously.
It is disabled by pressing the Button or turning the Motor off.
F
Starts the 24H function, in which the motor starts at a speed that
allows suction of 100 m3/h for 10 minutes per hour. This mode
cannot be activated if Intensive or Delay modes are active.
To deactivate it, press the same button or button A.
pressing and holding this button for approximately 5 seconds.
These indications are only visible when the motor is turned off.
G
Activates Delay mode, causing automatic shutdown of the Motor
and the Lighting system with a 20' delay.
It is disabled by pressing the button or turning the motor off.
Pressing and holding the button for 5 seconds enables the
remote control.
Pressing and holding the button for 5 seconds disables the
remote control
intensity.
H
Press and hold the button for 2 seconds to turn the Courtesy
Lights On (if provided).
Lighting
• For replacement contact technical
support ("To purchase contact
technical support").
Led
The Leds indicating the Speed of the motor turn off.
All the Leds light up in cycle and run a start-up sequence.
The Leds indicating Speed one and Motor Off turn on.
The Leds indicating Speed two and Motor Off turn on.
The Leds indicating Speed three and Motor Off turn on.
The Leds indicating Speed four and Motor Off turn on.
lights up.
The Leds indicating 24H speed and Motor Off turn on.
24H Led Flashing:
alarm is triggered after the Hood has been in operation
for 100 working hours.
The Delay and Motor Off button Leds turn on.
Delay Led Flashing:
triggered after the Hood has been in operation for 200
working hours.
The Led on the button lights up.
The Led on the button lights up.
5

Publicité

loading