Rothenberger ROCAM 4 Plus Instructions D'utilisation page 40

 Position camera head (1) with cable (4) into the reel (8).
 Bayonet connection operated by a half turn, and pulling gently (hold counterpart).
 Use caution not to damage the connector!
 Loosen locking bolts by pulling gently from the lock and Turning it 90 °. Restrain reel (8) to
prevent from slipping.
 Push reel (8) toward T-slot and remove the side. Use caution not to damage the connector.
 Mount in reverse order, paying attention when inserting the reel (8) on mark.
The software automatically detects the connected camera head.
4.11 Charger and battery
Overview:
1 Battery pack
2 Sliding seat
Operation display
3
Start of operation
Before plugging in, check to see that the rated mains voltage and mains fre-
quency, as specified on the rating label, match your power supply.
Devices such as this one, which generate direct current, may have an effect on basic residual-
current circuit breakers. Use type F or better, with a release current of max. 30 mA.
Before commissioning the charger, ensure that the air slots are free. Minimum
distance to other objects is 5 cm.
Self-test:
 Insert mains supply plug.
The warning display (4) and the operating indicator (3) light up one after the other for approx. 1
second and the installed fan runs for approx. 5 seconds.
Battery pack:
Charge the battery pack before use (1).
If performance diminishes, recharge the battery pack.
The ideal storage temperature is between 10°C and 30°C. The permissible storage temperature
is between 0°C and 50°C.
Li-ion battery packs have a capacity and signal indicator: (6)
 Press the button (5), the LEDs indicate the charge level.
If one LED is flashing, the battery pack is almost flat and must be recharged.
Handling
Charging battery pack:
 Push the battery pack completely to the stop on the sliding seat (2).
The operating indicator (3) flashes.
Conservation charge:
Once the charging process has finished, the battery charger automatically switches to conserva-
tion mode.
The battery pack can remain in the battery charger and is therefore always ready for use.
The operating display (3) lights up continuously.
Fault:
● Warning display (4) lights up continuously.
36
4 Warning display
5 Capacity indicator button
Capacity and signal indicator
6
ENGLISH
(C)