Specifications - Sony SCD-XA5400ES Mode D'emploi

No video is output from the HDMI OUT jack.
• The HDMI OUT jack of the player outputs blue
signal in the NTSC system only. It does not output
any other video signal.
No sound is heard, and "Unmatched Sink"
appears on the display.
• The component connected to the HDMI OUT jack
cannot receive the output signal of Super Audio
CDs. Connect the component to the ANALOG
OUT jacks.
The TIME/TEXT, MULTI/2CH, SA-CD/CD
buttons on the player do not light up.
• The TIME/TEXT, MULTI/2CH, SA-CD/CD
buttons do not light up. The states of these button
settings are shown on the display window.
No sound is heard, and "Press Stop" appears
on the display.
• When the player is in the HDMI ON mode, if you
connect the player and the amplifier while you are
playing back a Super Audio CD, sound may not be
output. Stop playback once, then start playback
again.
No sound is heard, and "Connected DVI"
appears on the display.
• If a DVI connection is made to the HDMI OUT
jack, no sound will be output. Connect the player
to an HDMI component that comply with audio
input.
After you have attempted the
prescribed corrective actions
If the player still does not operate properly, or if
other problems not described above occur, turn
off the player, unplug it from the power outlet
for a few minutes, then reinsert the plug into the
power outlet.
Note
When you turn on the power of the player, you may
hear a rattling sound from inside the player. This is
because the player is determining the type of disc or
making adjustments, and does not indicate a
malfunction of the player.

Specifications

When a Super Audio CD is played
Playing frequency range
Frequency response
Dynamic range
Total harmonic distortion rate
Wow and flutter
When a CD is played
Frequency response
Dynamic range
Total harmonic distortion rate
Wow and flutter
Output jacks
Jack type Output
ANALOG Phono
OUT UN- jacks
BALANCED
ANALOG XLR
OUT
BALANCED
HDMI HDMI
DIGITAL Square
OUT (CD) optical
OPTICAL* output
connector
DIGITAL Coaxial
OUT (CD) output
COAXIAL* connector
PHONES Stereo
phone jack
* Outputs only the audio signals of the CD
2 Hz to 100 kHz
2 Hz to 50 kHz (–3 dB)
110 dB or more
0.0012 % or less
Value of measurable limit
(±0.001 % W. PEAK) or
less
2 Hz to 20 kHz (±0.5 dB)
100 dB or more
0.0017 % or less
Value of measurable limit
(±0.001 % W. PEAK) or
less
Load
level impedance
2 Vrms Over 10
(at 50 kilohms
kilohms)
2 Vrms Over 600
(at 50 ohms
kilohms)
–18 dBm (Light
emitting
wave
length: 660
nm)
0.5 Vp-p 75 ohms
5 mW 32 ohms
continued
GB
29