Maytag MMV5165AA Guide D'utilisation Et D'entretien page 21

Care and Cleaning
CARE AND CLEANING
For best performance and safety, keep
the oven clean inside and outside.
Take special care to keep the inner
door panel and the oven front frame
free of food or grease build-up. Never
use rough powder or pads. Wipe
the microwave oven inside and out,
including the hood bottom cover, with
a soft cloth and a warm (not hot) mild
detergent solution. Then rinse and
wipe dry. Use a chrome cleaner and
polish on chrome, metal and aluminum
surfaces. Wipe spatters immediately
with a wet paper towel, especially after
cooking chicken or bacon. Clean your
oven weekly or more often, if needed.
CLEANING THE GREASE
FILTER
CAUTION
To avoid risk of personal injury or
property damage, do not operate
oven hood without filters in place.
The grease filter should be removed
and cleaned often, at least once a
month.
1. To remove grease filter, slide filter
to the side. Pull filter downward and
push to the other side. The filter will
drop out.
2. Soak grease filter in hot water and
a mild detergent. Rinse well and
shake to dry. Do not use ammonia
or place in a dishwasher. The
aluminum will darken.
3. To reinstall the filter, slide it into the
side slot, then push up and toward
oven center to lock.
CHARCOAL FILTER
REPLACEMENT
If your oven is vented inside, the
charcoal filter should be replaced
every 6 to 12 months, and more often
if necessary. The charcoal filter cannot
be cleaned. To order a new charcoal
filter, contact the Parts Department at
your nearest Authorized Service Center
or call 1-800-688-9900 (inside U.S.A)
or 1-800-688-2002 (Canada).
Order Charcoal Filter kit #: MVHRK5.
1. Unplug oven or turn off power at the
main power supply.
2. Remove the two vent grille mounting
screws. (2 outer screws)
3. Tip the grille forward, then lift it out.
4. Push the right side lower part of the
charcoal filter.
5. Remove old filter.
6. Slide a new charcoal filter into place.
The filter should rest at the angle
shown.
7. Slide the bottom of the grille into
place. Push the top until it snaps into
place. Replace the mounting screws.
Turn the power back on at the main
power supply and set the clock.
21