Télécharger Imprimer la page

Futurelight PCC-1200 Mode D'emploi page 34

Changeur de couleurs professionnel

Publicité

Les langues disponibles

Les langues disponibles

DMX-controlled operation
You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.
Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the PCC-1200 will respond to the controller.
Please, be sure that you don't have any overlapping channels in order to control each PCC-1200 correctly
and independently from any other fixture on the DMX-chain.
If several PCC-1200 are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the PCC-
1200 via your lighting controller.
Note:
The modes of DMX 512 data are shown via the display:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the the display will show "A.001" with the actually set address. If there is no data received at the
DMX-input, the display will flash "A001" with the actually set address.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last device in the link in order to
ensure proper transmission on the DMX data link.
34/83
00026337.DOC, Version 1.4

Publicité

loading