Publicité
Les langues disponibles
Les langues disponibles
Registering the
camera to your hub
Do not perform this procedure if
you are using the camera by
itself (i.e., you do not have a
KX-HNB600 hub). Use the initial
setup procedure (page 18).
If you want to integrate your HD
camera with a Panasonic Home
Network System, you must
register the camera to the hub.
Registering the camera
Confirm the following before you
begin.
– Make sure you can use your
mobile device to access the hub
– Make sure the hub's firmware is
up to date and that you are
using the latest version of the
[Home Network] app.
For more information, refer to
the System Setup Guide
included with your hub and the
User's Guide (page 30).
1
Plug in the camera and wait
about 1 minute for the
camera's LED to light in green.
R If the LED does not light in
For assistance, visit www.panasonic.ca/english/support
HNC805C_(en_en)_0902_ver.110.pdf
All manuals and user guides at all-guides.com
green, or if you experience
trouble during this
procedure, reset the
23
camera (page 24) and
then repeat this procedure.
2
Start the [Home Network]
app.
3
From the [Home Network]
app home screen, tap
[Settings].
4
Tap [Device Registration] ®
[Registration] ® [HD
Camera] ® [Method 1].
5
When prompted, press the
MSETUPN button on the back
of the camera.
R The camera registers your
mobile device.
R The app's home screen is
displayed when registration
is complete.
6
Follow the on-screen
instructions. When prompted,
set the password that will be
used to access the camera.
Note:
R When registration is complete,
the hub sounds one long beep.
R If registration fails, the hub
sounds several short beeps.
Setup
23
2016/09/05
13:39:11
Publicité
