ECOVACS ROBOTICS DEEBOT N79 Manuel De L'utilisateur page 5

22� Turn OFF the power switch before cleaning or maintaining the Appliance�
23� The plug must be removed from the receptacle before cleaning or maintaining the Charging Dock�
24� Remove the Appliance from the Charging Dock, and turn OFF the power switch to the
Appliance before removing the battery for disposal of the Appliance�
25� The battery must be removed and discarded according to local laws and regulations before
disposal of the Appliance�
26� Please dispose of used batteries according to local laws and regulations�
27� Do not incinerate the Appliance even if it is severely damaged. The batteries can explode in a fire.
28� When not using the Charging Dock for a long period of time, please unplug it�
29� The Appliance must be used in accordance with the directions in this Instruction Manual�
ECOVACS Robotics cannot be held liable or responsible for any damages or injuries caused
by improper use�
30� The robot contains batteries that are only replaceable by skilled persons� To replace or
remove the battery, please contact Customer Service�
31� If the robot will not be used for a long time, fully charge the robot and power OFF for storage
and unplug the Charging Dock�
This device complies with Part 15 of the FCC Rules / Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation�
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment�
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules� These limits are designed to provide
reasonable protection against harmful interference in a residential installation� This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications�
However, there is no guarantee that interference will not occur in a particular installation� If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna�
— Increase the separation between the equipment and receiver�
— Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected�
— Consult the dealer or an experienced radio/TV technician for help�
To satisfy FCC / IC RF exposure requirements, a separation distance of 20 cm or more
should be maintained between the antenna of this device and persons during device
operation�
To ensure compliance, operations at closer than this distance is not recommended�
To disable Wi-Fi module on DEEBOT, turn the robot's Bottom Power Switch ON� Place
the robot on the Charging Dock making sure the Charging Contacts on DEEBOT and the
Charging Dock Pins make a connection� Press and hold the AUTO Mode Button on the robot
for 20 seconds until DEEBOT emits 3 beeps�
To enable Wi-Fi module on DEEBOT, turn the robot's Bottom Power Switch OFF and then
power ON� The Wi-Fi module is turned on when DEEBOT is restarted�
1. Important Safety Instructions
3
EN