Publicité
Les langues disponibles
Les langues disponibles
Installation
Instructions
C2.__.. ATTACH THE MOUNTING
PLATE
TO THE WALL (cont.)
To use toggle bolts"
Mounting
Plate
Spacing for Toggles More
Than Wall Thickness
I Toggle Wings
Belt End
3.
Place the mounting
plate against
the wall and
insert the toggle wings into the holes in the wall to
mount the plate.
NOTE:
Before tightening
toggle
bolts and wood
screw, make sure to coincide
bottom
line of the
Mounting
plate with Horizontal
line of "Rear wall
Template"
and then the Mounting
plate is properly
centered
under the cabinet.
CAUTION:
Be careful to avoid pinching
fingers
between
the back of the mounting
plate and the wall.
4, Tighten
all bolts. Pull the plate away from the wall
to help tighten the bolts.
C3. USE TOP CABINET
TEMPLATE
FOR PREPARATION
OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough
for the power
cord to fit through.
•
Read the instructions
on the TOP CABINET
TEMPLATE.
•
Tape it underneath
the top cabinet.
•
Drill the holes, following
the instructions
on the
TOP CABINET
TEMPLATE.
CAUTION:
Wear safety goggles
when drilling holes in
the cabinet bottom.
C4. ADAPTING
MICROWAVE
BLOWER
FOR OUTSIDE
BACK EXHAUST
1, Remove
and save screw that holds btower Plate
to microwave.
Blower motor
screw.
2,
Lift up the Blower
Plate.
Blower Motor
Back of
Microwave
"_'_r..... Blower Motor
Screw
3, Carefully
putt out the blower
unit. The wires will
extend far enough
to allow you to adjust the
blower unit.
End B
CAUTION:
Do not touch blade of blower to prevent
cracking
and breaking.
Hold outer case when the
blower is removed
and re-installed.
4, Remove
"Parts "A" with Nipper or Scissors
Knockouts
Parts'A"
5. Rotate blower
unit counterclockwise
180 °.
Before Rotation
Back of
Microwave
After Rotation
Back of
Microwave
19
Publicité
