Publicité
SETTING SURFACE CONTROLS
When changing from a high heat setting to a lower heat
setting, the surface unit may stop glowing. This is normal.
To turn on a single surface unit
(Right Rear, Left Rear, Left front)
1. Touch ON/OFF for the desired
element position. The display will
flash
(The display will disappear if not
used after 10 seconds.)
2. Touch
power level Hi or
3. Use the
desired power setting.
(Adjustable at any time while the
element is ON.)
4. To turn off the Element after
cooking, touch ON/OFF once.
• Each time a pad is pressed a beep will sound.
Note:
• The power level decreases or increases by 0.5
from 9.0 through 3.0. (by 0.2 from 3.0 through
1.0)
• Lo is the lowest power level available.
To scroll through the power levels quickly press and
Note:
hold the
or
key pads until the power level
desired is reached.
CAUTION
• DO NOT touch surface elements until it
has cooled down sufficiently.
- The surface elements may still be hot and burns may
occur.
CAUTION
• NEVER leave food unattended at high or
medium-high setting.
- Boilovers can cause smoking and greasy spillovers
may catch on fire.
All manuals and user guides at all-guides.com
SURFACE CONTROLS COOKING
.
once to turn on the
once for Lo.
/
to choose the
/
is continuously accessible.
To turn on a dual surface element
(Right Front Inner, Outer)
1. Touch ON/OFF. The display will
2. Touch SELECT as needed to select
Setting
Single light
• Single Element (9" element)
Dual light
• Dual Element (9" and 12" elements)
3. Touch
4. Use the
5. To turn off the element after cooking,
• Each time a pad is pressed a beep will sound.
Note:
• The power level decreases or increases by 0.5 from
9.0 through 3.0. (by 0.2 from 3.0 through 1.0)
• Lo is the lowest power level available.
To scroll through the power levels quickly press and
Note:
hold the
or
desired is reached.
• DO NOT touch surface elements until it
has cooled down sufficiently.
- The surface elements may still be hot and burns may
occur.
- 10 -
flash
.
(The display will disappear if not used
after 10 seconds.)
the desired element size. The light
above SELECT indicates which size
surface unit is on.
Size of Element
once to turn on the power
level Hi or
once for Lo.
/
to choose the desired
power setting.
/
is continuously
accessible. (Adjustable at any time
while the element is ON.)
touch ON/OFF once.
key pads until the power level
CAUTION
Publicité
