Publicité
REMOVING & REPLACING THE
WARMING DRAWER
To Remove Warming Drawer:
1. Open the drawer to the fully opened position.
2. Remove the 2 screws (right and left sides). (refer to the
illustration as below)
3. Locate glide lever on each side of drawer, push down on
the left glide lever and pull up on the right glide lever.
4. Pull the Warming Drawer away from the range.
CAUTION
• Turn POWER OFF before removing the
Warming Drawer.
- Failure to do so can result in severe personal injury,
death or electrical shock.
Remove screw
Lever
Push down with finger
To Replace the Warming Drawer:
1. Replace shield on the right glide of the drawer body.
2. Pull the bearing glides to the front of the chassis glide.
3. Align the glide on each side of the drawer with the glide
slots on the range.
4. Push the drawer into the range until levers click
(approximately 2 inches). Pull the drawer open again to
seat bearing glides into position. If you do not hear the
levers click or the bearing glides do not feel seated,
remove the drawer and repeat steps 2-4.
This will minimize possible damage to the bearing glides.
All manuals and user guides at all-guides.com
MAINTENANCE
Lever
Pull up with finger
- 35 -
OVEN VENT
The oven vent is located above the left rear surface unit.
This area could become hot during oven use.
It is normal for steam to come out of the vent.
The vent is important for proper air circulation. Never block
this vent.
Publicité
