Siemens PAM0720 Mode D'emploi page 36

Dehumidification via the removable tank:
• Check that the removable tank is fitted onto
the appliance properly and that the plug is
fitted onto the water drainage pipe to prevent
water from leaking onto the support surface.
• When the water in the removable tank
reaches a certain level, the appliance beeps
twice. The removable tank full symbol
appears on the screen at the same time to
indicate that the tank needs to be emptied.
The appliance stops working when this
happens. The symbol also appears and the
appliance beeps when the removable tank is
not properly fitted into its housing.
• In both events, it is necessary to extract the
tank and pour the water carefully down the
nearest drain.
Dehumidification in continuous mode:
• Place a receptacle at the end of the water
drainage pipe to collect the condensed
water or lead the pipe to the nearest drain.
• Remove the plug from the water drainage
pipe on the back at the bottom of the unit.
The appliance does not stop working in this
mode. It does not beep or display the
symbol when the external receptacle is full.
• Select the dehumidification function
"Selecting the operation function").
• Select the operation speed, (see "Selecting
the speed").
Warnings
The amount of water dehumidified may vary
depending on ambient conditions (See
" Technical Information").
When the appliance is operating in the
dehumidification function, the temperature
does not appear on the screen and cannot
be selected or modified.
Warning!
Do not forget to replace the plug onto the
water drainage pipe when you change
function, otherwise the appliance will shed
water when operated.
Remember that ambient temperature must
be 18°C or higher in order for the appliance
to work.
Instructions for Use
The appliance expels hot air through the
drainage pipe when operating in the
dehumidification function. This is
necessary for the appliance to work more
efficiently in this operation function.
Air purification
The air inside the room (ventilation) is
circulated through a purifying system (air
purification) when the appliance is set to this
function.
The appliance comes with a basic filter
(already fitted on the appliance) and a double
active filter to be fitted by the user, see "Fitting
the purifying filter (double active)", against:
- Smells and smoke.
- Pollen, bacteria and dust.
J Plug the appliance into the mains electricity
supply.
J Fit the hot air expulsion tube (see
"Preparing the appliance before use").
J Lift the air director on the top of the
appliance.
J Select the air purification function
"Selecting the operation function").
J Select the operation speed, (see "Selecting
the speed").
(see
Important
We recommend you leave the filters in
position regardless of the function setting
(air conditioning, dehumidification, air
purification) in order to purify the air more
effectively.
Selecting the temperature
This function is only available in the cooling
function.
Place the selection box on the temperature
selection menu (see "up" and "down" keys).
Use the "+" and "–" keys to move within the
selection box until the desired temperature is
reached (see "+" and "–" keys).
The "+" key increases the desired temperature
and the "–" key reduces the desired
temperature.
The temperature selectable ranges from 18°C
to 30°C and can be set to the nearest 1°C.
Keep the key pressed in to increase or
decrease the desired temperature more
quickly.
36
, (see