Siemens PAM0720 Mode D'emploi page 34

Permanent installation
Performed using the wall grommet accessory.
See "Description of accessories".
J To expel hot air through the wall, it is
necessary to make an 14-cm diameter hole
in the wall and fit the wall grommet, Fig. 15.
J Remove the diffusion sleeve and connect
the air expulsion tube to the accessory.
Notes
Do not extend the hot air expulsion tube
more than necessary (maximum length;
140 cm).
Do not form sharp bends when positioning
the tube, otherwise the correct expulsion
of hot air may be impeded. This may cause
a reduction in the cooling power and
performance of the appliance.
In order to achieve maximum cooling
efficiency and minimum noise levels, the
expulsion tube should be fitted above the
total height of the appliance, Fig. 16.
Instructions for Use
Fig. 14
24 - 38 cm. Fig. 15
Fig. 16
Turning the appliance on and off
Press the "On" / "Off" key
appliance.
Warning!
Make sure that the appliance is plugged
into the mains electricity supply.
Selecting the operation function
The following functions can be selected on
your appliance:
J cooling
.
J dehumidification
J air purification
34
90°
to start the
.
.
0°