Zanussi ZFP416X Notice D'utilisation page 60

Charcoal filter
6.2 Cleaning the grease filter
Filters are mounted with the use of clips and
pins on the opposite side.
To clean the filter:
1. Press the handle of the mounting clip on
the filter panel underneath the hood.
1
2
2. Slightly tilt the front of the filter
downwards, then pull.
Repeat the first two steps for all filters.
3. Clean the filters using a sponge with non
abrasive detergents or in a dishwasher.
The dishwasher must be set to a low
temperature and a short cycle. The
grease filter may discolour, it has no
influence on the performance of the
appliance.
4. To mount the filters back follow the first
two steps in reverse order.
Repeat the steps for all filters if applicable.
6.3 Replacing the charcoal filter -
optional
WARNING!
Depending on type, filter can be or
cannot be regenerated. Refer to the
leaflet provided with the filter.
The time of saturation of the charcoal filter varies depending on the type of cooking and
the regularity of cleaning the grease filter.
To replace the filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in this
chapter.
2. Pull the tabs towards the bottom part of
the filter.
3. Slightly tilt the front of the filter
downwards, then pull.
4. To install a new filter, perform the same
steps in reverse order.
In any case, it is necessary to replace the
filters at least every four months.
6.4 Replacing the lamp
This appliance is supplied with a LED lamp.
This part can be replaced by a technician
only. In case of any malfunction refer to
"Service" in the "Safety Instructions" chapter.
60