EINHELL TC-CL 18 Li H Mode D'emploi page 11

5. Operation
5.1 Charging the Lithium-Ion battery (not
included)
The corresponding instructions can be found
in the original operating instructions for your
charger.
5.2 On/Off switch (Fig. 1/Item 1)
To switch on:
Press the On/Off switch (1).
To switch off :
Press the On/Off switch (1) again.
5.3 Setting the lighting position (Fig. 3)
You can set any lighting position by moving the
lamp head (see Fig. 3).
5.4 Battery capacity indicator (Fig. 4 / item 5)
Press the battery capacity indicator switch (6).
The battery capacity indicator (5) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The temperature of the battery is too low. Remove
the battery from the device and leave it at room
temperature for a day. If the error occurs again,
this means that the battery has been completely
depth discharged and is defective. Remove the
battery from the device. Never use or charge a
defective battery.
6. Cleaning and maintenance
HAZARD!
Always take the battery out of the equipment
before starting any cleaning work.
6.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
Anl_TC_CL_18_Li_USA_SPK7.indb 11 Anl_TC_CL_18_Li_USA_SPK7.indb 11
EN
low pressure.
•
We recommend cleaning the equipment
immediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may
be aggressive to the plastic parts in the
equipment. Ensure that no water can get into
the interior of the equipment. The ingress of
water into an electric power tool increases the
risk of an electric shock.
6.2 Maintenance
There are no other parts inside the equipment
which require maintenance.
7. Disposal and recycling
The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
8. Storage
Store the equipment and its accessories out
of children's reach in a dark and dry place at
above freezing temperature. The ideal storage
temperature is between 41°F and 86°F
(5°C and 30°C). Keep the electric tool in its
original packaging.
The reprinting or reproduction by any other
means, in whole or in part, of documentation
and papers accompanying the products is
strictly subject to the express consent of Einhell
Germany AG.
Subject to technical changes.
- 11 -
31.08.2023 10:03:14 31.08.2023 10:03:14