Mark Klimat 15-15 Mode D'emploi page 3

Read this document before
installing the appliance
Incorrect installation, adjustment, alteration, repair or maintenance activity may lead to material
damage or injury. All work must be carried out by approved, qualified professionals. If the appli-
ance is not positioned in accordance with the instructions, the warranty shall be rendered void.
If the manual refers to an image or table, a number will be shown between square brackets, for
example [3]. The number refers to images and tables at the back of the manual with the stated
number.
1.0 General
1.1 Application
The Mark Klimat air handling unit can be used for a variety of air handling purposes. It is able to
supply various types of buildings and rooms with ventilation air, either hot or cool as required.
The size of the Mark Klimat depends on the number of ventilation cycles required, and the heating
and/or cooling capacity. The Mark Klimat is available in various dimensions and air quantities from
3 3
5000m /h to 69500m /h. The air handling unit can be supplied in a number of assemblies on re-
quest. From a simple ventilation unit suitable for air intake and exhaust to a mixing box, filtering,
heating, cooling, humidifying, heat recovery and sound attenuation unit. If heating areas in which
there are corrosive vapours (chlorinated hydrocarbons in particular) which are either produced
directly in the area, or may be drawn in from the outside by the air handling unit via a connection
or an open connector, indirect gas heaters cannot be used because of the risk of corrosion. Con-
sult the manufacturer for use in, or close to, swimming pools.
The unit is suitable for the operating parameters indicated on the type plate.
– Median temperature (air, water, coolant and air humidity)
– The unit must not be used in explosive area unless otherwise indicated.
– The maximum current consumption must not be exceeded.
You may deviate from the agreements above only with the manufacturer's agreement in writing.
Subject to change
The manufacturer is committed to constantly improving its products and reserves the right to
make changes in the specifications without prior notice. The technical details are considered cor-
rect but do not form the basis for a contract or warranty. All orders are accepted according to
the standard terms of our general sales and delivery conditions (available upon request).
All manuals and user guides at all-guides.com
Warning
EN
3