Uline CLASSIC Serie Instructions De Montage page 2

IMPORTANT! Turn cam lock 1/4 to the right to
lock.
IMPORTANT! FUNCTION OF CAM LOCK
Ensure the arrow is pointing to edge of
panel before inserting into the panel's hole.
NOTE: Use Phillips screwdriver to tighten cam
lock pins and cam locks.
NOTE: Assemble on a smooth, non-marring
surface to avoid scratching.
NOTE: Check that all parts are included.
1. Install one cam lock pin (A) in back panel (1).
Insert one cam lock (B) into corresponding hole in
bottom panel (2). Fit back panel and bottom panel
together and turn cam lock clockwise until it locks.
(See Figure 1)
NOTE: Cam lock caps can be applied once
cam locks are tightened for a finished look.
2. Install one cam lock pin (A) in bottom panel (2).
Insert one cam lock (B) into corresponding hole
in skirt panel (4). Fit bottom panel and skirt panel
together and turn cam lock clockwise until it locks.
(See Figure 1)
3. Install one cam lock pin (A) in center of back panel
(1). Insert one cam lock (B) into corresponding hole
in fixed shelf (3). Fit back panel and fixed shelf
together and turn cam lock clockwise until it locks.
(See Figure 1)
Figure 1
3
B
1 F
A
PAGE 2 OF 9
1/4 RIGHT TURN
FOR LOCKING
3
1
2
ASSEMBLY
4. Install six cam lock pins (A) and five dowels
(C) in side panel (5,6). Insert cam locks (B) into
corresponding holes on bottom panel (2), skirt panel
(4) and fixed shelf (3). Fit side panel together with
pieces assembled in Steps 1-3 and turn each cam
lock clockwise until it locks. Repeat for second side
panel. (See Figure 2)
5. Mount adjustable glides (D) on side panels (5,6).
Glides can be adjusted to compensate for uneven
floors. (See Figure 2)
Figure 2
6. With second person, set bookcase upright.
4
1
3
5
A
C
3
5
B
F
6
Tighten
6
D
0423 IH-6286MAH