Samsung CM1089 Serie Manuel D'utilisation page 17

USING MEMORY PROGRAMMING.
Press the Number buttons to select user-programmed memory
functions (please refer to memory programming) from 1 to 20.
Press the Start ( ) button.
If the DEFROST function is included in STAGE COOKING, it works at
first.
If you want to change program, just reset MEMORY PROGRAMMING.
USING THE CHECK BUTTON
Confirming the cooking time and Power Level in each memory program.
1. Clear all operations by pressing the Stop/Cancel
( ) button.
Press the Check ( ) button to enter Check
mode.
2. Using the Number buttons, enter the program
number from 1 to 20.
For example, suppose you press '5', for the
Memory Program 5 which is HI Power Level, I
Stage cooking with a time of 6 minutes and 30
seconds, 6:30.
First, '5' will be displayed. but will change to show the
3. After one second, the display will clear
automatically. If you want to check other Memory
Programs, just enter the Memory Program
numbers.
4. Press the Stop/Cancel (
Check mode.
CM1089A_XEU_DE68-03310E-03_EN.indd 17 CM1089A_XEU_DE68-03310E-03_EN.indd 17
) botton to exit the
Reading each Memory Program's Cycle Counter
1. Clear all operations by pressing the Stop/Cancel
( ) button.
Press the Check button to enter Check mode.
2. Press the Start ( ) button, and then press any
Number button, from 1 to 20, and the number of
cycles for that particular Memory Program will be
displayed. The cycle count is displayed in units of
10.
For example, if Memory Program 5 has been used
100 times, the display will show '10'.
As the display uses units of 10, the cycle counts are approximate. The
cycle count displayed increases every ten cycles.
For example, if the cycle count were 90-99, "9" would be displayed,
The "9" would change to "10" on the 100th cycle. The cycle counter
function has a limit of 99,990 cycles. Once that number is exceeded,
the cycle counter will automatically clear and start again from "0".
3. After one second, the display will clear
automatically. If you want to check other Memory
Programs, just enter the Memory Program
numbers.
4. Press the Stop/Cancel ( ) button to exit the
Checking mode.
17
10/26/2022 7:00:18 PM 10/26/2022 7:00:18 PM