Inventum PW720ZW Mode D'emploi page 12

4
before first use
Before you use the appliance for the first time, please do
as follows: carefully unpack the appliance and remove all
the packaging material. Keep the material (plastic bags and
cardboard) out of reach of children. Check the appliance after
unpacking for any damage, possible from transportation. Place
the scale on a firm, flat surface. Remove the batteries from the
protective packaging and insert with the correct polarity. See
the diagram inside the battery compartment.
Press the UNIT button on the back of the scale to select the
correct measuring unit (kg/st/lb).
kg = kilograms
lb = pounds
st = stone
Place the scale on a flat and stable surface and wait for the scale
to turn itself off.
5
personal data
You must enter personal user parameters in order to measure
your body fat percentage and other physical data. The scale has
8 memory positions in which you and other members of your
family can save and retrieve personal settings. Now you can
enter the following setting:
Memory position (P)
Body size
Age
Gender
Sportsman or -woman
• Press the SET key when the display is
switched off to change the setting. The first
memory position P1 flashes on the
display. To select the correct user, press the
or keys and press the SET key again to
confirm.
• After you have entered the correct user, the symbol for
gender will blink. To select the gender (male, female,
sportsman, sportswoman), press the
the SET key again to confirm.
• After you have entered the gender, the indication for body
size (height) will blink (preset 165 cm). To set your own height
press the or keys and press the SET key again to
confirm.
• After you have entered your body size, the indication for age
will blink (preset 30). To set the correct age (male, female,
sportsman, sportswoman), press the
the SET key again to confirm.
12
• English
1 to 8
80 to 220 cm
6 to 100 years
male ( ), female ( )
or keys and press
or keys and press
After all parameters have been entered, you can now measure
your weight, body fat and the other data. The display will show
0,0 kg.
Stand on the scale barefoot and let the scale perform a
measuring. When you step on the scale the next time the scale
will recognize you. When you step off the scale, the scale will
switch off after a few seconds.
TIP: To reset a memory position for another user perform the
same steps as described above. All positions are preset.
6
weigh only
The scale has a step-on function. Step barefoot
onto the scale. Stand still with your weight
distributed evenly on both legs. The scale will
start measuring your weight immediately and a
short time later will display your weight. When
you step off the scale it will turn off after a few
seconds.