Philips HF8430 Mode D'emploi page 8

EnglisH
8
Note: The appliance may produce a smell the first few times you charge it. This is normal.
, When the battery is fully charged, the light ring goes out.
candlelight set
Charge the candlelight set for 12 hours.
When the candles are fully charged, they have an operating time of approx. 24 hours.
1 Insert the small plug into the charger and put the adapter in the wall socket.
, The charging light on the charger goes on (Fig. 3).
2 Put one or more candles on the charger (Fig. 4).
, When the candles are fully charged, the charging light on the charger goes out and the
charging process stops.
Note: The candles may go on when you put them on the charger. If they do, remove the candles from the
charger and tilt them to switch them off. Then put the candles back onto the charger.
Note: For safety reasons, a built-in timer stops the charging process after 12 hours, when the batteries
are fully charged. If you have one or more uncharged candles left and want to charge them right away,
press the button on the charger to start another charging cycle. When you do this, the charging light goes
on again.
Preparing for use
massager
cleaning
Thoroughly clean the massager before first use, after every use and when you use it on another
body area, to reduce the risk of infection (see chapter 'Cleaning').
Pre-warming the massager
The charger has a pre-warming button that you can use to pre-warm the bottom of the massager
to a comfortable temperature (approx. 40°C).
Never warm the massager in an oven or microwave.
1 Place the massager on the charger. It only fits properly on the charger with the buttons facing
up.
2 Press the pre-warming button (Fig. 5).
, The pre-warming light ring starts flashing to indicate that the massager is warming up.
, After approx. 5 minutes, the pre-warming light ring stops flashing and lights up continuously
to indicate that the massager has reached a comfortable temperature.
, After 30 minutes, the pre-warming function automatically switches off, but you can also
switch it off by pressing the pre-warming button again.
using the appliance
massager
1 Press any button to switch on the massager (Fig. 6).
, The light ring goes on.
, The massager starts operating in the default mode (mode 1) and at moderate vibration
speed.
Tip: We advise you to start in the default mode. You can gradually increase the vibration speed once you
are familiar with the options.
Note: If you feel uncomfortable during use, you can adjust the vibration speed. See step 3.
All manuals and user guides at all-guides.com