Lux Tools E-RT-550/27 Mode D'emploi page 24

All manuals and user guides at all-guides.com
Rasentrimmer_401129_401130.book Seite 24 Freitag, 21. Oktober 2016 9:03 09
GB
• Only take the thread as close as absolutely nec-
essary to posts, walls, fences etc. Solid objects
will wear the thread.
• Tree trunks, young trees and bushes may be
damaged by the thread.
Trimming edges
WARNING! Risk of injury! When using the
cutting head upright, particular care should
be taken. Always maintain sufficient dis-
tance to the cutting thread.
NOTICE! Risk of damage to the unit!
Avoid contact with solid surfaces to prevent
rapid wear of the thread.
Note: The guide roller (6) only serves for
easier guidance when trimming edges. It
should not be used for brush cutting and
has no influence on the cutting height.
► P. 4, item 6
– Press in and hold the locking button (10).
– Rotate the cutting head (9) by 90°.
– Release the locking button (10) again.
– Guide the unit, as shown, slowly along the edge
of the lawn (► P. 4, item 8).
Cleaning and maintenance
DANGER! Risk of injury! Prior to conduct-
ing maintenance or cleaning: Unplug from
the power source.
Cleaning and maintenance overview
Note: Clean unit immediately after every
use. Dried grass remains are very hard, and
are very difficult to remove.
Before each use
What? How?
Check the power cable Conduct a visual inspec-
and connector for dam- tion and have the cable
age. replaced by an electrician
if necessary.
Error/Fault
The motor does not work.
Threads don't unwind.
If you can't fix the fault yourself, contact your nearest
vendor. Please be aware that any improper repairs
will also invalidate the warranty and additional costs
may be incurred.
24
If necessary
What?
Cleaning the device
Replace thread if it is too
short
Replacing the thread spool
Removing the thread spool
► P. 4, item 9
– Press the locking mechanism (17) in.
– Remove the cover (18).
– Pull out the cord spool.
Inserting the thread spool
► P. 4, item 9
– Feed both threads in the openings (19) of the
spool housing.
– Press the thread spool into the spool housing.
Pull the threads out through the openings.
– Mount cover(18) and allow to engage.
Storage, transportation
Storage
– Store the tool in a dry and well ventilated place.
Transportation
– When dispatching, try to use the original pack-
aging, if possible.
Troubleshooting
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the
vendor. You will save yourself a lot of trouble and
possibly money too.
Cause
No power supply?
Defective connecting cable?
Thread used up?
Thread spool blocked?
Disposal
Disposal of the appliance
Appliances which are labelled with the adja-
cent symbol must not be disposed of in
household waste. You must dispose of such
old electrical and electronic equipment sep-
arately.
– Please check with your local authority about the
possibilities for correct disposal.
How?
Wipe the unit with a damp
cloth.
► Replacing the thread
spool – p. 24
DANGER! Risk of injury! Unprofessional
repairs may mean that your unit will no
longer operate safely. This endangers you
and your environment.
Remedy
Check the cable, plug, and the fuse.
Contact your local vendor.
► Replacing the thread spool –
p. 24.
Remove the cause of the blockage
(► Removing the thread spool –
p. 24).