Smeg BLC01 Instructions Importantes page 11

Proceed as follows to activate the ICE CRUSH
program:
• Press the button of the program. The LED of
the button lights up with a fixed light, while
the other buttons switch off.
• The display shows the pre-set preparation
time.
• Press the dial knob ring to start the program.
The display shows the time remaining to the
end of the cycle (COUNT DOWN).
• The LED of the button selected remains on
with a fixed light during the activation cycle,
while the other buttons are off.
• The cycle ends automatically and the
blender goes into stand-by mode. The
display shows the Stand-by icon (21) and
the button LEDs are off.
• To PAUSE the blender, press the dial knob
ring. The count down flashes slowly and
the button of the program selected has a
fixed light. Press the dial knob ring again
to resume processing.
T• o stop the program, press the key of the
selected preset program or the knob for 2
seconds. The selected button switches on,
while all the others are off.
• To change program, press the desired
program button.
Pulse function
The PULSE function can only be activated
when in manual mode (speed 1-8) or also
autonomously. In manual mode, by pressing
the PULSE button the product operates at
maximum speed and the display shows speed
9. The blender goes back to the previously set
speed when the button is released.
In case it is desired to activate autonomously,
make sure the knob is in Manual mode. By
pressing the PULSE button the product operates
at maximum speed and the display shows
speed 9. The motor stops but the display shows
the speed on which the appliance stopped
before pressing Pulse.
The PULSE key lights up only when you enter
Manual mode (M icon).
Use
The PULSE button only lights up when the knob
is turned and the speed is different than 0.
The PULSE function does not work
with pre-set programs.
How to use the vacuum pump
accessory (Fig. F)*
The vacuum pump must be activated
before any blending cycle.
Always wait for the vacuum pump
to stop before activating any cycle.
Do not blend any ingredients while
the vacuum pump is operating, to
prevent damage to the pump.
Also, if your food doesn't have a liquid
element - herbs, spices, or nuts, for
example - vacuum blending will not
have a noticeable impact.
• Unscrew the base of the accessory to check
for the presence of the 4 batteries inside
(BATTERIES NOT INCLUDED).
• Introduce the ingredients into the jug and
close with the lid.
• Replace the measuring cup (1) on the lid
with the vacuum pump cap (10).
• Place the vacuum pump (9) above the cap
(10).
• Activate the pump by pressing its upper
button.
The button LED lights up with a fixed light.
• The accessory stops automatically once the
vacuum pressure inside the jug has been
reached. The button LED switches off.
• Remove the vacuum pump (9) from the cap
(10) of the blender.
• Activate the blender by selecting the manual
speed or the desired pre-set program.
• When the cycle has ended, press the cap valve
to release the pressure of the blender jug.
• Remove the jug cap.
*Standard on certain models. Also available as optional accessory.
EN - 11