Smeg BLC01 Instructions Importantes page 10

Manual Function
• Turn the knob clockwise to select the desired
speed.
• The display shows the selected speed and
the icon "M" steady on.
• Press the dial knob ring to start the blender.
• The display will show the time of use (count
up) starting from 0:00.
• Turn the knob clockwise to increase speed
or anti-clockwise to decrease it. The
motor increases or decreases the speed
consequently, the display shows the speed
selected for 1 second, after which it goes
back to showing the advancement of time
(COUNT UP).
• To put the blender in PAUSE mode, press
the dial knob ring, the "COUNT UP" flashes
slowly. To resume processing, press the dial
knob button again.
• To stop processing and return to manual
mode, press any key or the knob for 2
seconds.
• After 10 seconds of inactivity, the blender
goes automatically into Stand-by.
The speed can be changed at any
time in manual mode during the
blending process.
After 3 minutes of continuous
operation in the speeds between
1 and 8, the blender stops and
automatically goes into stand-by.
By activating the blender at speed
9 for a maximum of 6 minutes,
soups can be heated from room
temperature and after cooking.
For the denser preparations, use the
tamper to convey the ingredients
into the cutting area.
EN - 10
Use
Single/Family serve mode and
preset programs
The Single/Family modes allow the blender
to be used with quantities for single portions
(SINGLE serve) or multi-portions (FAMILY serve).
The Single or Family mode can only be
activated with the pre-set Smoothie, Green
Smoothie and Frozen Dessert programs. For
additional details, consult the "Suggestions for
use/Speed settings" table.
Proceed as follows to activate one of the two
modes:
• Press the button of 1 of the 3 programs
desired. The LED of the button lights up with
a fixed light, while the other buttons switch
off.
• The display shows the FAMILY SERVE
mode icon (25) by default and the pre-set
preparation time.
• Turn the knob to select SINGLE SERVE
mode. The display shows the icon (24) and
the pre-set preparation time.
• Press the dial knob ring to start the program
selected. The display shows the time
remaining to the end of the cycle (COUNT
DOWN).
• The LED of the button selected remains on
with a fixed light during the activation cycle,
while the other buttons are off.
• The cycle ends automatically and the
blender goes into stand-by mode. The
display shows the Stand-by icon (21) and
the button LEDs are off.
• To PAUSE the blender, press the dial knob
ring. The count-down flashes slowly and all
the keys have a fixed light. Press the dial
knob ring again to resume processing.
• To stop the program, press one of the preset
function keys or the knob for 2 seconds.
The selected button switches on, while all
the others are off.
• To change program, press the desired
program button.