Publicité
Les langues disponibles
Les langues disponibles
Keep the appliance away from
direct sunlight and heat
sources like the heater.
To prevent the lint from blocking
cascade outlet during washing,
please keep the lint filter in good
condition, install it to proper
position and clean it in time.
Installation and adjustment
Please install and adjust the machine according to the requirements of the
manual.
It is very important to your safety and correct operation.
Unpacking
Unpack the carton and take out the bottom panel.
Open the top lid of washing machine and take out all of the
accessories.
Remove all wrappers, including the polystyrene base.
You are advised to keep all the packaging for reuse in case the
machine is to be transported again.
08
Any objects such as coins, safety
pins, nails, screws, stones or any
other hard, sharp material can
cause extensive damage and
must not be placed into to the
machine.
Before washing, please ensure
that the tap is open and the
inlet hose is installed properly.
It is suggested to use low foam
washing powder.
Installing the bottom cover
As shown in the picture, put down
the machine from side, put down the
machine on some soft thing, please
let the remarkable face outside, the
arrow direction is machine front side.
Align the screw hole between bottom
and bottom cover, use the appendix
screw to fasten the bottom cover.
Positioning
The distance between the washing machine and the wall should be
more than 2 inches(50mm), and the maximum allowed angle of the
shank base of the machine is 45°. The slanting or rough ground may
cause operating.
Make it horizontal
Use a tied thread with plumb to check
if it is horizontal.
Adjust the adjustable foot
1. Lift the adjusting foot side of the washing machine
slightly and rotate the adjusting foot.
2. Adjust the adjusting foot to a proper height to make
the washing machine stable.
45°
09
Publicité
