Publicité
Les langues disponibles
Les langues disponibles
It does not inlet
· No water supply
· Tap is not open
· Inlet hose gets blocked
Spin stops and
Laundries is too much or too
begins to inlet
little or the machine is not
during spin
placed stably
program
Press the program
· Do not close the top lid
button to
when
select SPIN, but it
drain is finished
does not spin.
· Open up the top lid when
start drain
The spin is
Balance the laundries to
intermittent when
reach to the best spin effect
spin starts
First time to use,
The remaining water when
some water flows
the factory make test
from the drain hose
Notes: If there is still a fault after the above checks, please pull out the plug
and contact the after-sales service center right away. It is dangerous to
repair this product by yourself.
20
Restart when water supply
is resumed
Open the tap
Clean the filter according
to before "clean inlet gate"
The machine is adjusting
automatically
· Close the top lid
· Close the top lid
Normal
Normal
Other functions
1. Give an alarm
Display
Explanation
The top lid is opened
when preset is started
After draining 5
minutes, it still does
not reach to water
level
The top lid is open
when spinning.
Spin does not balance
After inlet 50 minutes
still not reach to
setting water level
The water level is
more than overflowing
water level.
The input and output
of the memory is
abnormal.
Water level sensor is
wrong.
Settlement
Close the top lid and clear up the
alarm.
Open top lid, according to before
troubleshooting and settlement to
settle it, then close the top lid and
clear up the alarm.
Close the top lid and clear up the
alarm.
Open the top lid ,make the laundries
place equally, then close it and clear
up the alarm
Open top lid, according to before
troubleshooting and settlement to
settle it. Then close the tip lid and
clear up the alarm
Drain the water until the water level
reach the
Close the top lid and clear up the
alarm.
Cut the power supply and call the
technicians.
21
Publicité
