Epson TM-U295 Manuel D'utilisation page 6

English
Control Panel
RELEASE button
Press this button to insert or remove paper.
REVERSE button
Feeds paper backward.
FORWARD button
Feeds paper forward.
POWER LED
ON when the printer is on.
RELEASE LED
ON when the printer is in release mode (to insert or remove paper).
OFF when the printer is in clamp mode (to hold paper).
FLASHES to indicate an error.
PAPER OUT LED
ON when paper is not inserted or is not inserted correctly.
Removing the Transportation Damper
The printer is protected during shipping by
a transportation damper that you must
remove before you turn on the printer.
Pull the damper out and remove the strip
of tape from the top of the printer, as
shown in illustration 1.
Note:
Prepare the printer to ship or store with
these steps: turn on the printer, press the RELEASE button, press the
FORWARD button, turn off the printer, and reinstall the transportation
damper.
Installing a Ribbon
Use the Epson ERC-27 ribbon cassette. The use of any ribbon cassettes other
than those approved by Epson may damage the printer and will void the
warranty.
1. Turn the printer on using the power switch on the left side.
2. Press the RELEASE button (the RELEASE LED lights). This puts the
printer in the paper release mode.
3. Turn the printer off.
Perform the steps above to make sure the printer is in the paper release mode
before you install or remove a ribbon cassette.
6 TM-U295/U295P User's Manual
CAUTION:
1