CASUALPLAY Baby 0+ SAFE TECH Manuel D'instructions page 20

• Put the parking brake on.
• Place the Baby 0 SAFE TECH on the pushchair, facing backwards.
+
• Line the Unisystem fasteners on the Baby 0
• Press downwards until it clicks fastened and a green signal appears in each of the windows on the sides of
the fasteners (fig.21).
• To take the Baby 0
+
window) and pull upwards to release it from the pushchair chassis (fig.22).
Using the Baby 0 SAFE TECH as a rocker
+
• Place the Baby 0 SAFE TECH on the floor on a flat surface.
+
• Move the handle to the rocker position (consult the section about how to adjust the carrying handle). Make sure
that it clicks into position (fig.5) (C).
• The Baby 0 SAFE TECH will move as your baby moves.
+
• The baby should wear the harness fastened and should never be left alone.
WARNING: Never leave the child unsupervised.
Using the Baby 0 SAFE TECH as a seat
+
• Place the Baby 0 SAFE TECH on the floor on a flat surface.
+
• Move the handle to the stability position (consult the section about how to adjust the carrying handle). Make
sure that it clicks into position (fig.5) (A).
• The Baby 0 SAFE TECH can now be used as a seat for the baby.
+
Removing the upholstery
• Unfasten the safety harness and take the shoulder protector pads off.
• Turn the Baby 0 SAFE TECH round. Then undo the 4 fastening hooks found on the sides, and the plastic
+
strips.
• Lastly, pass the straps and the buckle through the slots in the upholstery.
• To fit the upholstery back onto the Baby 0
NOTE: It is very important that the protector pads are fitted back on. They are an important safety element and
must be used always.
Fitting the mosquito net (depending on the model)
• Unfold the hood. Undo the zip, found on the top part of the hood, and take the mosquito net out.
• Spread it out, fasten the elastic strip and the clips on the sides.
• To put the net away undo the side clips and the elastic strip. Roll it up and store it in the pocket.
Maintenance
• Clean the plastic parts with mild soap and warm water.
• Wash the upholstery and fabric parts by following the washing instructions indicated on the different fabric
care labels.
All manuals and user guides at all-guides.com
SAFE TECH off, press and then release the red button on both fasteners (red signal in the
+
SAFE TECH up with the slots (fig.20).
+
SAFE TECH follow the same steps in reverse order.