CASUALPLAY Baby 0+ SAFE TECH Manuel D'instructions page 18

harness of the seat.
• Remember that you are responsible for the child's safety.
Instructions for use
Fitting the hood
• Place the hood on the Baby 0
• Lastly, fasten the Velcro on the hood to the rear part of the backrest.
Fitting the foot cover
• Place the foot cover on the Baby 0
feet (fig.2).
Adjusting the hood
• The hood has several positions.
• To unfold it, pull the hood upwards (fig.3). Do the opposite to fold it.
Adjusting the carrying handle
• Make sure you change the handle position correctly (fig.4-5).
A. Stability.
B. Installing on a pushchair.
C. Carrying, rocking, installing in the car using the Base fix Baby 0
D. Installing in the car.
• Press the two buttons on both sides of the handle to change its position.
• Move the handle to the required position until it clicks into place.
Headrest adaptor
• The headrest adaptor is designed to provide side support for the baby's head and can be adjusted as the baby
grows.
• It is advisable to use the headrest adaptor while it is suitable for the baby.
• When you need to remove the headrest adaptor, simply unfasten the harness buckle, remove the chest
protector pads and pass the harness straps through the openings in the headrest adaptor.
• Fit the chest protector pads again.
• To fit the headrest adaptor, follow the same steps in reverse order.
Adjusting the height of the harness
• Find the distribution plate found on the back of the Baby 0
straps of the harness (fig.6). Pass the shoulder straps out through the slots in the backrest and in the upholstery.
• Insert the shoulder straps through the appropriate slots (fig.7) and insert them back into the metal plate,
making sure that they are correctly positioned. Check that the straps are not twisted.
IMPORTANT: where the straps come out of the backrest, they should be at the height of the child's shoulders
and both at the same level (fig.8).
IMPORTANT: Make sure that the harness straps are not twisted.
Opening and closing the harness buckle
• Bring the two parts of the harness chest straps together and insert them into the female part of the buckle.
Then press them both until they click fastened (fig.9).
• To undo the buckle, press the red button.
Safety harness
• Loosen the shoulder straps by pressing the button that slackens them while using the other hand to pull the
shoulder straps upwards (fig.10).
• Unfasten the harness by pressing the red button and place the shoulder straps at the sides of the seat.
• Settle the child in the Baby 0
All manuals and user guides at all-guides.com
SAFE TECH and insert the two ends into the guides (fig.1).
+
SAFE TECH, fasten the Velcro on the sides and the elastic band on the
+
SAFE TECH and put the harness on. Make sure that the straps are not twisted.
+
SAFE TECH (sold separately).
+
SAFE TECH backrest and release the two shoulder
+