Publicité
Les langues disponibles
Les langues disponibles
Delay Hours (on some models)
Use this option to run your dishwasher during off-peak hours. Local utility providers recommend using energy during
off-peak hours when possible.
To delay the start
1. Select a wash cycle and options.
2. Press the delay button to choose the number of hours to be delayed.
3. Press START/RESUME and firmly close the door within 3 seconds.
NOTE: Anytime the door is opened (such as, to add a dish), the START/RESUME button must be pressed again, within
3 seconds of closing the door, to resume the delay countdown.
Control Lock Option
Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When LOCK ON is lit, all
buttons are disabled. The dishwasher door can still be opened/closed
while the controls are locked.
To turn on the Lock
Press and hold HEATED DRY for 3 seconds. LOCK ON will light up. If you press any pad while your dishwasher is
locked, the light flashes 3 times.
NOTE: The dishwasher cannot run if the control is locked.
To turn off the Lock
Press and hold HEATED DRY for 3 seconds. The light turns off.
Status Indicator Lights (on some models)
ABC
Front Panel Lights - The left light indicates the dishwasher is in the
wash cycle. The middle light indicates the dishwasher is in the dry cycle.
The right-hand, green or blue Clean light indicates the cycle is complete
and ready to unload. If the Clean light is blinking, see "Troubleshooting"
section.
A. Wash cycle
B. Dry cycle
C. Clean light
Canoe
ng A Cyce
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door.
2. Press CANCEL/DRAIN button once. The Cancel/Drain light will light up.
3. Close the door within 3 seconds. The dishwasher starts a drain cycle (if water remains in bottom of dishwasher). Let
the dishwasher drain completely. The Cancel/Drain light turns off after 2 minutes.
You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
2. Check that detergent dispenser cover is still closed. If cover is open, you will need to refill the detergent dispenser
before restarting your new cycle.
3. Press CANCEL/DRAIN twice to reset the control.
4. Select new cycles and options.
5. Press START/RESUME and firmly close the door within 3 seconds.
NOTE: If the door is not closed within 3 seconds of pressing Start/Resume,
press START/RESUME again.
L_/., @#¢;u,> el" <,
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
2. Check whether the detergent dispenser cover is still closed. If it is open, the wash cycle has already started and
adding a dish is not recommended.
3. If detergent has not yet been used (detergent dispenser cover is closed), you may add a dish.
4. Press START/RESUME and firmly close the door within 3 seconds.
18
Publicité
