Powerplay SPYDER SPY2KCOS Instructions D'assemblage, D'entretien Et D'utilisation page 12

Operating Instructions
Operation Tips
• When using detergent, fill bottle with a properly
formulated detergent-to-water ratio, following
instructions on the container.
• DO NOT use thick, gel-like detergents, as they will clog
the power washer and can cause damage.
• It is normal to hear the motor run intermittently when
the trigger is not being squeezed. The pump is priming
itself to operate when the trigger is squeezed.
• Turn off the power washer if not being used after five
minutes.
• The O-rings in the hose should be cleaned regularly
and lubricated with non-water soluble grease such as
petroleum jelly.
• Keep the spray tip cleaning wire nearby for unclogging
the tips.
How to Avoid Damaging Surfaces
• Damage to surfaces being cleaned occurs when
the impact force of the water pressure exceeds the
durability of the surface. Bare wood can be penetrated;
paint can be peeled off, etc. You can vary the force of
the power washer by adjusting:
1. The angle of the nozzle to the surface being
cleaned.
2. The distance from the nozzle to the surface
being cleaned.
• NEVER use a narrow, high-pressure stream of water on
soft surfaces.
• When cleaning windows, it is recommended to use
a minimum of 25° spray tip to protect the glass. A
0° spray tip is to concentrated of a spray and may
shatter the window. Position spray tip at a 45° angle,
approximately four to five feet away from the window.
Squeeze the trigger and vary the spray pattern and
angle until optimum cleaning efficiency is achieved.
All manuals and user guides at all-guides.com
Using the Foam Cannon
1. Unscrew fluid tank from foam cannon valve assembly.
2. Fill fluid tank with water (for best results, use warm
3. Add 1-3 ounces of your favorite detergent to the fluid
4. Attach fluid tank to foam cannon valve and attach
5. When finished, run clean plain water through the
11 12
water.)
tank.
assembly to the gun. Use the control knob to change the
flow of soap + (more) or - (less).
pressurized foaming system to purge soap from the
internal components.
Flush with hot water for added cleansing power.