Powerplay SPYDER SPY2KCOS Instructions D'assemblage, D'entretien Et D'utilisation page 11

Assembly Instructions
13
D
Important Initial Startup
Release the spray gun safety lock (K) on the spray gun (J).
Remove spray tips/nozzles form the lance. Point the spray
gun in a safe direction and squeeze the trigger until there is
a steady stream of water, releasing water and air out of the
hose. Then turn the machine to the "ON" position starting
the motor, press and hold the trigger on the spray gun for
30 Seconds to flush the system of any foreign material that
may block the spray tip or nozzle, causing the machine to
"pulse on and off the pressure switch." Once completed
insert the spray tip of your choice.
Operating Instructions
1. Turn on water supply at the faucet.
2. Make sure the "ON/OFF" switch is in the "OFF"
position. The power switch has international
symbols: On (|) Off (O).
3. Completely unwind the power cord and plug into a
grounded 120 volt outlet.
4. Release the spray gun safety lock (I) on the spray gun
(H). Point the spray gun in a safe direction and squeeze
the trigger until there is a steady stream of water,
releasing water and air out of the hose. Lock the spray
gun.
5. Turn the power switch to the "ON" (|) position. The
unit will run on for 1 - 2 seconds and shut off. This is a
normal function of the auto-start feature.
All manuals and user guides at all-guides.com
Attach a garden hose to the garden hose adapter on the
back of the power washer unit (D).
Note: Flush out garden hose before connecting to garden
hose adapter.
Assembly is now complete. Read and observe all safety
instructions before turning on the power washer.
6. Begin power washing by squeezing the trigger all the
7. Release the trigger to stop the power washer.
8. Allow the motor to come to a complete stop before
9. Squeezing the trigger rapidly will cause the auto-start
10. ALWAYS test a small area to avoid damaging the
11 10
way into the handle.
squeezing the trigger again.
feature to miss an on/off cycle and may prevent the
washer from turning on. Use slow, deliberate trigger
pulls to avoid this.
surface.