Publicité
Les langues disponibles
Les langues disponibles
8.
Draw end of bunch marked with R through side ventilation grate to left standing lights (e.g. slightly cut plastic
edgeof ventilation grate and install bunch in the prepared cut).
9.
Disconnect 5-input plug connection of vehicle from standing lights and connect it to suitable joint of electric
bunch.Connect remaining joint of electric bunch to standing lights.
Fitting turn indicator relay and additional control light:
10.
a)
Remove the legroom cover under the dashboard on the driver's side.
b)
Remove the existing turn indicator relay and insert the supplied relay into its socket.
Note: A clicking sound will be heard when the turn indicator is activated.
c)
For the additional control light, drill a Ø 10 mm hole at a suitable place in the driver's field of view (e.g. an
unused switch faceplate). Lead the supplied cable for the control light from the relay to the backside of the
newly drilled hole. Push the two plug-in sleeves onto the control light and insert this into the mounting-hole.
Connect the 2-pin connector housing to the corresponding vacant connector slot of the relay.
Secure the cable set with supplied cable ties, re-install all trims and other parts which were removed during
installation.
Connect the earth lead to the battery and check all vehicle functions with connected trailer or suitable testing device
If the trailer is connected, the indicator lamp blinks when direction indicators (3 x 21W) or warning lights (6 x 21W)
are on.
Publicité
