Publicité
Les langues disponibles
Les langues disponibles
35 05 07R / 17.12.2020
Packing list:
1 8-conductor cable set
1 Socket 7-pin
1 Socket retaining plate
1.
Disconnect the earth lead from the battery
2.
Remove inside boot screens near standing lights.
3.
Draw connection bunch outside, through ventilation grate to left and right standing lights.
Connect bunch to socket in the following way:
4.
a)
Draw end of bunch through hole near connection socket handle,
b)
Draw attached rubber socket retaining plate over the end of cable set (if necessary use anti-friction
agent),
c)
Disassemble the socket and connect cables according to the following assignment::
7 pin
Function
Indicator left
Fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
Fog light
5.
Push the socket with rubber retaining plate and screw the socket tightly onto the retaining plate using the supplied
nuts and screws:
a)
Pay special attention to the right position of rubber retaining plate,
b)
Put the cable set gently to avoid any folds and to secure it from possible wiping.
Draw end of bunch marked with L through side ventilation grate to left standing lights (e.g. slightly cut plastic
6.
edgeof ventilation grate and install bunch in the prepared cut).
7.
Disconnect 5-input plug connection of vehicle from standing lights and connect it to suitable joint of electric
bunch.Connect remaining joint of electric bunch to standing lights.
Electrical Set for Trailer Connection
7-pin
SEAT | Inca | 11.1995 -
VW | Caddy | 11.1995 -
Part no.:.
WYR
1 Relay with C2 output
1 Green control light
1 Cable for control light
Installation instruction
Contact description
Cable colour
1
(L)
white
2
(54-G)
grey
3
(31)
brown
4
(R)
green
5
(58-R)
purple
6
(54)
red/black
7
(58-L)
black
8
(58-b)
grey/white
350507R
3 Screws M5X35
3 Spring washer
3 Nuts M5
Contact description in
4 Cable ties 300 mm
4 Cable ties 100 mm
1
2
6
7
3
5
4
8
7-pin socket
Publicité
