Vaporesso LUXE Q2 SE Mode D'emploi page 5

ENGLISH
USER INSTRUCTIONS
1. Install & Replace the Pod
Pull out the pod from the battery and install the new
one.
*If it's the first time using the device, please tear off
the sticker of the pre-installed pod.
2. Fill the E-liquid (Refer to FIGURE 1)
3ML :
Pull out the silicon plug then squeeze the e-liquid
through the filling slot. After filling, put the silicon plug
back and make sure it's shut firmly.
2ML :
Snap off the mouthpiece then squeeze the e-liquid
through filling slot. After filling, put the mouthpiece
back and make sure it's shut firmly.
*If it's the first time filling the e-liquid, please wait 5
minutes for the coil to prime.
3. Start Vaping
The device is draw-activated. Inhale through the
mouthpiece and exhale to start vaping.
4. Charging
Please use the in-box Type-C cable to charge the device.
The LED indicator will stay on white while charging and
shut off while fully charged.
PROTECTIONS
Low Resistance/Short-circuit: The device will stop
working and the LED will stay on white in 2s.
Low Voltage: The device will stop working and the LED
will flash 10 times.
Over Charging: The device will flash 3 times and stop
charging.
Overtime(10S): The device will stop working and the LED
will flash 2 times.